
Shaft Seals High Pressure O-Ring
Material: Nitrile/NBR/Buna, FKM/FPM, Silicone, EPDM, HNBR, NR, FFKM, FEPM, etc.
Zhejiang Jiacheng New Material Co., Ltd. is one of the leading manufacturers and suppliers of shaft seals high pressure o-ring in China, also supports customized service. Welcome to wholesale bulk high quality shaft seals high pressure o-ring in stock here from our factory. If you have any enquiry about quotation and free sample, please feel free to email us.

Size: Standard and Custom made
Material: Nitrile/NBR/Buna, FKM/FPM, Silicone, EPDM, HNBR, NR, FFKM, FEPM, etc.
How to Install the Shaft Seals High Pressure O-Ring
When using an O-ring on a shaft, the inner diameter of the O-ring is generally smaller than the diameter of the shaft, and it should be slightly tightened to prevent it from falling off.
For use in the hole, apply the O-ring to the hole. Generally, the outer diameter of the O-ring should be slightly larger than the hole diameter to prevent it from falling off.
When using in grooves, knowing the groove size of the O-ring, how to choose the O-ring size? Select a suitable O-ring based on the groove diameter, groove width, groove depth, and when the diameter of the O-ring is flattened, leave an allowance for the groove.
About pressure
In dynamic sealing, when the pressure is greater than 10MPa, the O-ring will be squeezed into the gap and damaged. Therefore, a PTFE or nylon retaining ring made of PTFE or nylon should be installed on the low-pressure side of the O-ring, with a thickness of 1.25~2.5mm. When subjected to high pressure in both directions, retaining rings should be added on both sides.





Hot Tags: shaft seals high pressure o-ring, China shaft seals high pressure o-ring manufacturers, suppliers, factory, Automotive Fuel Resistant O Rings, Food Safe O Rings, High Density O-Rings, Rubber O Rings, Heavy Duty O Rings, Custom Made O Rings
Send Inquiry
