What should I do if the fluororubber O-ring fails?

Viton O-rings are prone to failure due to factors such as improper use in daily work, such as overheating of the rubber ring and other failures. The failure of the fluororubber O-ring not only delays the daily work, but also wastes manpower and material resources and causes losses. Therefore, it is necessary to be familiar with the solutions for different situations. Chuyue Rubber Products summarized the following methods:
1. Overheating of fluororubber O-ring If the fluororubber O-ring fails to overheat, check the condition of the centrifugal pump sealing chamber and its cooling device as soon as possible. This inspection is mainly to check whether there is a blockage in the equipment. If there is a blockage, it should be cleaned up in time. the
2. Improper selection of specifications. If the fluororubber O-ring is not properly selected, it will cause permanent deformation and affect the use. Not only will the fluororubber O-ring lose its original performance and break, but it will also prevent the sliding parts from moving. So the choice must be careful and match. the
3. Extrusion of fluororubber O-ring The fluororubber O-ring sometimes has a small space, and when the space is small, extrusion will occur. At this time, all parts of the fluororubber O-ring should be adjusted immediately to improve the situation in the narrow space. the
Hope it helps you.